© 2015 Breezy Special Ed. Justine Template designed by Georgia Lou Studios All rights reserved.
: Connects the external UHF radio whip antenna.
Ensure no other controller is paired with the receiver. Restart both the receiver and the controller.
Set the antenna height and select the UHF protocol (e.g., Hi-Target/TrimTalk). Start the base transmitter. Operating as a Rover Select Survey > Rover Setup .
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. V30 Plus GNSS RTK System User Manual
Understanding the physical layout and indicators of your Hi-Target V30 Plus is essential for troubleshooting and efficient field operation. Visual Indicators and Buttons hitarget v30 plus manual
Verify that Base and Rover share identical frequencies, protocols, and baud rates. Distance too far or radio interference. Keep the field controller within 5 meters of the receiver. 8. Care and Maintenance
Disconnect from the Base and connect to the Rover via Bluetooth. Go to -> Rover . Set the Data Link to match the Base (e.g., Internal UHF).
Open the battery side compartments, slide the batteries into the slots matching the metallic contacts, and snap the latches shut.
Select your device S/N and tap . A successful audio confirmation will trigger: "Device connected." 4. Configuration Modes Configuring the Base Station (Internal UHF Mode) Go to the Device menu and tap Base . Data Link Selection: Set the Data Link to Internal Radio . : Connects the external UHF radio whip antenna
Your receiver (the "Rover") needs to talk to your handheld controller.
A: Yes, IP66 allows heavy rain, but the manual explicitly says do not submerge it (IP67 is required for submersion). Dry the battery contacts before charging after wet use.
: Used for external power supply and NMEA data output.
Input the known coordinates of the point, or select "Get Current Coordinates" for an autonomous start. Set the antenna height and select the UHF protocol (e
Warning: Wrong operation may damage the machine, lose data, or endanger safety. Always refer to the official manual contained in the instrument container.
Select the same radio protocol and frequency used by the base station.
Hi-Target V30 Plus GNSS RTK System: Complete User Manual & Configuration Guide