Mount the torque bar to the mechanical unit and attach the rubber damper to the console to absorb vibration.
Torque wrench, Allen keys (4mm, 5mm, 6mm), spirit level, socket set, multimeter, and insulated screwdrivers. 2. Step-by-Step Mechanical Installation
: Use the Up/Down buttons to move the door until the bottom edge aligns exactly with your 1 m mark.
: Lock the external side of the drive assembly with the secondary stop ring. crawford cdm9 950 installation manual
Inspect the encoder cable connection to the main board. Ensure the locking collar is tight and the shaft is not slipping inside the operator sleeve.
Tighten all mechanical mounting bolts and keyway set screws.
The you are currently encountering.
Clean the door shaft extension and remove any burrs or rust. Insert the keyway key into the shaft slot. 2. Mounting the Operator Slide the CDM9 950 drive sleeve onto the door shaft. Align the torque arm with the wall anchoring point.
Test all safety devices (photocells, safety edge, and emergency stop) to confirm they interrupt door travel.
After digging into the Crawford CDM9/950 swing-arm mechanism installation, here’s a proper breakdown for anyone mounting this into a CD player or transport project. Unlike standard Philips swing-arm units, the Crawford version has specific mechanical and electrical nuances. Mount the torque bar to the mechanical unit
: Ensure the drive unit location resides at least 2.5 meters above the floor level to avoid accidental physical interference.
Turn on the main power supply to the ECS 950 control box. 3.2. Setting Limit Switches (Using ECS 950)