Huawei Atn 910d-a Datasheet [cracked]
The Huawei ATN 910D-A is a case-shaped routing platform designed for 5G mobile backhaul, enterprise leased lines, and metro aggregation networks. As part of Huawei's NetEngine ATN series, this multiservice access router helps operators navigate the transition from legacy transport architectures to high-bandwidth, low-latency 5G transport networks.
"How?" Elena asked.
Equipped with 1588v2, G.8275.1, and Synchronous Ethernet clock capabilities to solve timing problems in mobile packet transport. Huawei Atn 910d-a Datasheet
The ATN 910D-A runs on Huawei's VRP (Versatile Routing Platform) operating system. It supports an array of modern IP/MPLS features. Layer 2 and Layer 3 Features
The table below outlines the core hardware parameters of the Huawei ATN 910D-A platform. Specification Details 1U (44.45 mm) Dimensions (H x W x D) 44.45 mm × 442 mm × 220 mm Switching Capacity Up to 156 Gbps (bidirectional) Forwarding Performance Up to 130 Mpps Weight (Fully Loaded) Approximately 4.5 kg Typical Power Consumption ~75W (configuration dependent) Operating Temperature -40°C to +65°C Operating Humidity 5% to 95% RH (non-condensing) Interface Configuration The Huawei ATN 910D-A is a case-shaped routing
No built-in firewall or IPS (design assumes external security appliances).
Given its high capacity and feature set, the ATN 910D-A is ideally suited for several demanding scenarios: Equipped with 1588v2, G
Your targeted (e.g., standard IP/MPLS , SR-MPLS , or native SRv6 )?
"We didn't lose a single packet," Elena breathed. "The cars didn't even brake."
| Card Model | Interface Type | Port Count | Use Case | |------------|----------------|-------------|-----------| | | T1/E1 (channelized) | 8 ports | Legacy TDM backhaul | | SIC-4GEF | GE (optical/electrical) | 4 ports | Ethernet aggregation | | SIC-2XGF | 10GE SFP+ | 2 ports | High-bandwidth uplinks | | SIC-8FE | Fast Ethernet (RJ45) | 8 ports | Low-speed sensor/device aggregation | | SIC-2GEC | GE combo (copper/SFP) | 2 ports | Flexible media conversion |
Pingback: DTLS 1.2 and Cisco LWAPP / CAPWAP APs: On shooting yourself in the foot