Inside the VCDS software configuration menu, navigate to the "Options" tab, select "Advanced Options," and set the update frequency check to "Never" .
Most USBASP programmers use a 10-pin ribbon cable, whereas VCDS clone boards usually present smaller solder pads or pinheaders. Female-to-female Dupont jumper wires are ideal for making direct connections.
Most VCDS cables have a 6-pin or 10-pin header (labeled J4 or similar) on the PCB for In-System Programming (ISP).
USBasp VCC → Board VCC (Only if you are powering the board via the programmer) USBasp GND → Board GND Step 3: Flash the ATmega162 Microcontroller vcds atmega162 reflash 2021
avrdude -c usbasp -p m162 -U flash:r:backup.hex:i
This process is generally for enabling clone hardware and does not bypass the need for a legal license if you are using official Rosstech software. Always use the loader provided to prevent the cable from being blacklisted by Ross-Tech servers.
Connect the programmer to the ISP header on the board. You may need to solder pins if they aren't populated. 3. Flashing Procedure (The "Reflash") Inside the VCDS software configuration menu, navigate to
Reflashing a VCDS interface with an ATmega162 chip involves using an external programmer, such as the MiniPro TL866+, to restore firmware and EEPROM files. Successful repair often requires utilizing specific loader software, updating fuse bits, and ensuring the interface is properly configured to prevent re-bricking. For a full guide and download resources, visit Programming Atmega 162
Plug the cable into your PC. Open Windows Device Manager. It should display under Universal Serial Bus Controllers as a specialized interface, not a generic serial port.
Reflashing a VCDS interface with an chip is a common procedure for repairing "bricked" third-party cables or updating them to work with newer software versions, such as those released in 2021 (e.g., version 21.3 or 21.9). 1. Identify Your Hardware Most VCDS cables have a 6-pin or 10-pin
Connect the USBasp programmer to these pins using the wiring schematic above. 2. Reading and Clearing the Chip Plug the USBasp programmer into your computer's USB port.
chip. Reflashing only works for this specific chip, not for newer ARM or NEC-based interfaces. Bootloader Status: VAGCOM_HWType.exe
There are two primary ways to update or restore an ATmega162 interface depending on its current state: Method A: Software-Only (If Bootloader is Active)