Metric Allen wrenches (hex keys), screwdrivers (flathead and Phillips), open-ended wrenches, and wire cutters.
: Slide the power pack (motor and carriage) onto the rail. The Levant uses a rack-and-pinion drive system .
: Place the rail sections on the stairs with the gear rack facing upward toward the center of the staircase. thyssenkrupp levant stair lift installation manual full
Wire the charger/transformer and plug it into a nearby 220V (or local equivalent) outlet.
Tighten all bolts securing the rail to the steps. B. Installing the Carriage and Chair Metric Allen wrenches (hex keys), screwdrivers (flathead and
: Install the low-voltage wall transformer near a standard GFCI electrical outlet at either the top or bottom of the stairs.
Connect the batteries within the motor housing. : Place the rail sections on the stairs
Move the entire rail assembly into its final position on the stairs. Maintain a standard clearance distance from the wall (typically 5 to 6 inches) to allow room for the seat back. Step 3: Anchoring the Rail
Swivel the seat away from the riding position. Attempt to drive the lift. The unit must not move until the seat is locked back into its parallel travel position. Troubleshooting Common Installation Issues Probable Cause Resolution Lift will not move; continuous beeping. Battery disconnected or main power off.
The (often branded under TKE or HomeGlide ) is a straight-rail stairlift designed for quick installation directly onto the stair treads rather than the wall . Levant Installation Overview
Push the second rail section firmly against the first, ensuring the gear racks align perfectly. A gap in the gear rack will cause the carriage to stall or jump.