| Code | Function | Description | |------|----------|-------------| | P1 | Over-voltage cutoff | Load disconnects if voltage > this value | | P2 | Over-voltage reconnect | Voltage must drop below this to re-engage | | P3 | Under-voltage cutoff | Load disconnects if voltage < this value | | P4 | Under-voltage reconnect | Voltage must rise above this to re-engage | | P5 | Over-current cutoff | Load disconnects if current > this value | | P6 | Delay time (seconds) | Delay before reconnecting after fault | | P7 | Start delay | Delay before relay engages on power-up |
Follow these steps carefully to prevent damage to the module, your battery, or connected equipment.
The XY-CD60 is an intelligent voltage controller module used to automate and protect the charging and discharging cycles of various batteries, including Lithium and Lead-Acid types, within a DC 6V to 60V system.
Users can set a "Charging Time" (OP) to limit how long a battery remains connected to a charger, regardless of voltage. Serial Communication: xycd60 manual
HD LCD showing real-time voltage, battery percentage, and operating time. Control Method:
The Xycd60 device comes with a range of innovative features and functions. Here are some of the key highlights:
The is a DC 6V–60V battery charge and discharge controller designed to automate battery maintenance and prevent damage from overcharging or deep discharging. It functions as a voltage-sensitive relay, acting as an automated switch between your power source and the battery. 🛠️ Key Specifications Operating Voltage: DC 6V–60V. Maximum Current: Generally rated for 10A through the relay. Control Precision: 0.1V. Modes: Charging (P-1/IN) and Discharging (P-2/OUT). It functions as a voltage-sensitive relay, acting as
A short press of the DOWN button manually toggles the relay, instantly cutting power if needed. XY-CD60 Solar Battery Charger Controller Module User Manual
The is an intelligent, programmable voltage control switch designed to manage battery charging and discharging cycles . Operating across a wide voltage range of DC 6V to 60V , this compact board acts as a safety relay to protect lead-acid, lithium-ion, LiFePO4, and other rechargeable battery chemistries from catastrophic overcharging and over-discharging.
Make sure to hold the set button until the screen flashes to confirm changes. The display flashes "IN".
Protects against over-discharge (undervoltage). The relay stays closed to power the load until the battery hits the lower limit ( dn ), at which point it disconnects to prevent battery damage. Interesting Technical Highlights
This flashlight offers two distinct control interfaces. You can use the tail switch as the primary master power control for turning the light on or off, and the side switch to cycle through modes and settings.
The relay turns on when the voltage is above the upper limit (UP) and turns off when it drops below the lower limit (dn). Additional Features
XY-CD60 Solar Battery Charge Controller Module - RoboFactory
When the detected battery voltage falls below or equals the configured Lower Limit Voltage ( dn ), the onboard relay turns ON (closes the circuit), and external charging current flows into the battery. The display flashes "IN".
