Cobra 3195 Alarm Manual //top\\ Full -

Connect to a wire that reads +12V only when key is in "ON" and "START". Indicator Lights Connects to the vehicle's left indicator circuit. Yellow / Green Indicator Lights Connects to the vehicle's right indicator circuit. Black / White Bonnet Switch (-)

: Uses secure, random rolling codes to prevent signal grabbing.

Cobra 3195 is a modular alarm system typically controlled via the vehicle's original remote. While a single "full text" digital manual is rarely hosted as a plain text file, the system's operation and installation are covered by these key technical specifications and procedures: System Overview The 3195 is a CAN-bus or PLIP cobra 3195 alarm manual full

Before beginning installation or testing, ensure your vehicle electrical system matches the operational parameters of the Cobra 3195. Specification 12V DC (Negative Earth) Operating Voltage Range 9V DC to 16V DC Current Consumption (Armed) Siren Acoustic Output > 115 dB at 1 metre Operating Temperature -40°C to +85°C Remote Control Frequency 433.92 MHz (Rolling Code) 3. Wiring Diagram and Pin-Out Reference

: Press the large button again. The turn indicators flash once. Connect to a wire that reads +12V only

: Press the large button (Button A) on the remote. The system typically confirms this with visual flashes and optional audible signals.

: The system may automatically arm 60 seconds after the driver’s door is opened or 255 seconds after the engine is turned off. Black / White Bonnet Switch (-) : Uses

: Press the "Lock" button on your vehicle's original remote. The hazard lights will flash once, and the LED will begin to flash.

Press the large button (often "A") on the remote. Indicators flash twice, the LED illuminates, and doors lock.

The Cobra 3195 features two thick black wires dedicated to engine immobilization.

You can program up to 4 remote controls to work with the Cobra 3195. Programming Mode Activation Disarm the system. Turn the ignition switch .