Ats20 | Radio Manual Better Work

Best for AM broadcast stations to get high-fidelity audio.

If a local station is overloading the receiver, the audio will sound distorted. Press the button to cycle through: AGC Auto: The radio automatically adjusts sensitivity.

Drop the bandwidth down to 2.2 kHz or 3.0 kHz . This cuts adjacent channel interference and drops the noise floor. ats20 radio manual better

The single best method to make your ATS-20 radio work better is replacing the rudimentary stock firmware with the community-developed variations or the Harduino firmware. These updates unlock features like a visual S-meter, refined step sizes, scanning modes, and superior SSB stability. Step-by-Step Firmware Upgrade Guide

Let’s standardize the terminology. Most ATS20 units have the following physical controls: Best for AM broadcast stations to get high-fidelity audio

If a signal is overpowering and sounds distorted, check your firmware settings to switch from Auto Gain Control (AGC) to manual attenuation. Advanced: Firmware Upgrades

Before powering on the device, understanding the physical interface prevents configuration errors. Front Panel Interface Drop the bandwidth down to 2

: When in SSB mode, the rotary encoder often acts as a Beat Frequency Oscillator (BFO) control, allowing you to fine-tune the "pitch" of a voice to make it intelligible.

The ATS-20 radio is a powerful little receiver, but its small size hides complex functionality. Take 30 minutes to read the key sections, bookmark the menu reference page, and keep it handy. You’ll go from frustrated button-pusher to confident shortwave and SDR listener in no time.

Ensure the physical switch on the back is NOT on "FM" (it should be on AM/SSB).

Go to product viewer dialog for this item. Go to product viewer dialog for this item.