Stenhoj Ds2 Manual Official

If you do not have a physical copy, obtaining a digital version is the first step.

What is the listed on your lift's data plate (e.g., DS2 3000, DS2 3200)?

Ensure the area beneath the vehicle is entirely clear of tools, oil drains, and personnel.

Usually 3-phase, 400V, 50Hz (230V options available in some regions). Minimum Ceiling Height: Approximately 2,800mm - 3,000mm.

The Stenhøj DS2 is a surface-mounted, electro-mechanical (screw-driven) two-post lift. Unlike hydraulic lifts that rely on fluid pressure and cylinders, the DS2 utilizes a heavy-duty motor, a drive shaft (or chain, depending on the exact sub-model variant), and a precision-engineered screw-and-nut assembly inside each column to raise and lower vehicles. Key Specifications Overview Electro-mechanical (Lead screw) stenhoj ds2 manual

The Stenhoj DS2 is a screw‑type lift (skruvlyft), where threaded spindles (gängstången) are driven by an electric motor, often via a chain connecting the two posts. This design is known for its simplicity and low maintenance requirements compared to hydraulic lifts. The DS2 M&E version has a typical lifting capacity of .

Improper installation is the primary cause of early structural failure or tipping. The installation manual dictates strict parameters for the concrete floor supporting the pillars: Concrete Floor Preparation

Don't just guess the numbers. Here is what the manual actually recommends:

Since each post has its own motor, they are synchronized via a cable or electronic bridge. If the carriages become unlevel, the safety circuit will stop the lift immediately. 4. Maintenance Schedule If you do not have a physical copy,

: Minimum structural grade C20/25 (or equivalent new concrete standard B 4710-1) is required.

Raise the vehicle slightly (approx. 10–15 cm) until the wheels clear the floor.

While specific metrics can vary by the exact sub-model (e.g., DS2 630 vs. DS2 303), typical specifications for this generation of Stenhøj 2 -post lifts include:

Press and hold the "Up" button until the desired working height is reached. Usually 3-phase, 400V, 50Hz (230V options available in

If your model has an overhead bridge, install it now.Run the synchronization cables or chains through the crossbeam.Ensure equal tension to prevent the arms from lifting unevenly. Step 5: Electrical Connection

2,500 kg (2.5 tonnes) to 3,000 kg (3.0 tonnes) Country of Origin: Denmark (AutopStenhøj) 2. Unpacking the Stenhøj DS2 Manual: Core Sections

Keep a copy of the wiring diagram (Appendix C) laminated inside the battery compartment. When a fuse blows 3 hours into a night shift, that diagram is worth its weight in gold.

Complete inspection of all bolted connections and structural elements. Common Troubleshooting Issues